Error Dictfull

[ARTHUR@GUINEVERE.tamu.edu (Arthur Keen)]

I would like to know if anyone has experienced this error, and what can be done to work around it.

I cut a 3D picture of a side and face cutter which I had made in S-geometry, 
and imported it into the graphic editor of Concordia, where I put textual 
labels on it and drew a hatched cross section of a part to show the tool 
cutting into the part. On trying to hardcopy the picture, I got the following error:

Error: Dictfull
Offending Command: def

Stack:

0
/linebits
-savelevel-

This error was printed over the partially hardcopied file. 
By partial, I mean only the bitmap image had been printed. 
I blanked out the graphic editor additions and it printed ok, 
then blanked out the captured bitmap image and it also printed 
out ok, so my conclusion is that some undesired interaction had 
occured, or we need to allocate more lmfs or swap on our 
printserver. Does anyone have any ideas?



Arthur A. Keen 
Knowledge Based Systems Lab
Texas A&M University
College Station
Texas.