[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

end of line

I seem to remember that "end of line" command worked differently just
recently.  I think I remember that when a line was longer than my screen
and followed on the next line, if I did an "end of line" the cursor would
go all the way to the end of the line.  Now it just goes to the rightmost
position on the screen.  If I then do another "end of line" it now
goes all the way to the end.  Did this command change?  Is there a way
to set it backt to the previous behavior.  I like the old behavior better.